Known Limitations¶
What V3 can't do yet, or does with a caveat. Each item is also on the Roadmap.
Feeders¶
- One working feeder (F1). Feeders 2 and 3 were built but abandoned for this release: one servo stripped its gears, and the other feeder's lever did not reliably catch and release the tape holes. Jobs place one package type (0603 resistors on F1); other packages can be loaded by hand with the job's No feeders option.
- The feeder stroke is a plain 400 ms out / 400 ms back. Faster or ramped strokes bounced parts out of the pocket.
- Each feed waits for the servo (it does not overlap with motion yet).
Parts and accuracy¶
- Tested on 0603 and 0805 resistors with the N08 tip. Other packages are in the tables but not proven.
- Rotations at 45° landed about 4 - 5° short in early tests (0°/90° are within ±1°). Chip parts self-align in reflow; a correction can be added.
- The upside-down check works for resistors only (dark top vs white body).
- One nozzle: no tip changer. A job that needs two tips asks you to swap them.
Vision and setup¶
- Alignment starts from the last known board position: if the board is put down far from where
it was, center the down camera on pad A by eye first (
align-board). - Bright frame lights wash out the up camera's view of the nozzle bore: keep them at about 15 %.
check-machine --applyassumes the nozzle moved. If the up camera moved instead it gives a wrong offset: usecalibrate-offset(Recovery Check).- Sensorless homing alone lands 0.1 - 2 mm off; always use Vision home before work.
Machine¶
- Software emergency stop only (see Safety).
- Noise: the compressor and the venturi exhaust are loud; the sound level has not been measured yet. Wear hearing protection for long runs.
- The Pi 4 has 1 GB of memory: large installs must be done over SSH with the touchscreen stopped.
- Moonraker accepts commands from the whole local network without a login.
- No measured long-term (multi-hour) run yet; the longest recorded run is four 23-part jobs back to back.