Skip to content

4. Run a Job

A job running, seen from above (real speed).

Put the board on the plate

  1. Put the board against the fixed PCB mount, slide the adjustable mount up and tighten.
  2. Put it in roughly the same place and orientation as last time: the machine looks for alignment pad A where it last found it and searches a few mm around.

Board in a new place?

Centre the down camera on pad A by eye (Mainsail jog, Z 30 or higher), then run python -m pnpvision align-board "jobs/<job>.job.json" --rot 90 once. Every job after that finds the board by itself.

Start

  1. Touchscreen -> Pick & Place -> Job, tap the job.
  2. Check the details: parts to place, which feeder holds each package (a package with NO FEEDER is skipped unless No feeders is on), the estimate.
  3. Options: Align first on (recommended), No feeders off, Dry run off.
  4. Start -> confirm. The nozzle must be empty and the up light on.

What the machine does

  1. Vision home if needed.
  2. Align: the down camera visits pads A, B, C, fits the board's position and rotation, and reports the worst pad error. (Not counted in parts-per-hour.)
  3. For each part: feed, pick, check over the up camera, turn, place.
  4. Rejects (wrong size, empty nozzle, on its side, upside down) go to the reject bin, and the part is picked again - up to 3 tries, then the job stops and asks you.
  5. At the end: placed / failed and parts per hour, on the screen and in results/job_<time>.json.

During the job

  • The red JOB RUNNING line means: hands out of the work area.
  • Long runs: wear hearing protection (compressor and vacuum exhaust).
  • Questions (load a part, swap a tip, retry?) open as dialogs: answer on the screen.
  • Stop job (two taps): ends cleanly after the current part.
  • EMERGENCY STOP: stops everything now (Safety).
  • Don't jog or run other macros: other PnP buttons refuse while a job runs.

Dry run

With Dry run on, no parts are picked: the down camera visits every placement and saves a photo with a crosshair on the target, in job_<time>/. Use it for a new board or after re-calibrating.

From Mainsail or SSH

RUN_JOB JOB=Test_PCB-top-0603 ALIGN=1          (Mainsail console; spaces as _)
python -m pnpvision run-job "jobs/Test PCB-top-0603.job.json" [--dry-run] [--only R1 R2] [--no-feeders]

Next: After the job.