Skip to content

Teaching a Feeder

Tells pnpvision where a feeder's pick spot is and what package it holds. Do it once per feeder, and again if the feeder moves.

  1. Vision home. Feed a part into the pick window.
  2. Jog the nozzle (Mainsail, Z 30 or higher first) over the part, then lower it in small steps until it just touches the part.
  3. Save it:
    python -m pnpvision teach-feeder F1 --servo 1 --package R_0603_1608Metric
    
  4. --package must match the KiCad footprint name in your jobs.
  5. --value 10k limits the feeder to parts with that value.
  6. For a hand-loaded track without a servo: --manual --tape-angle <deg>.
  7. Lift the nozzle.

The saved spot is in calibration/feeders.json. During jobs the pick position refines itself from the up camera (how far off-centre each part was picked).

Check it with feeder-cycle.