Skip to content

Build

This section takes you from a donor Ender 3 to a machine ready for Software Setup.

Ongoing: V3 build guide

The V3 step-by-step assembly (with hardware counts and photos), the V3 bill of materials and the V3 wiring diagram are being written. Until then, these pages give the build order, the files to use and everything we learned the hard way. The V2 guide (in the History) shows the level of detail that is coming.

Order

  1. Print the parts
  2. Take apart the Ender 3
  3. Frame and motion: frame, CoreXY, toolhead, staging plate
  4. Electronics and wiring
  5. Pneumatics
  6. Feeder hardware
  7. Then: Software Setup and Calibration

Before you start

Tools

  • Metric hex keys (M3, M5 hardware; 1.5 mm for set screws) and a metric wrench set
  • Needle-nose pliers, wire strippers, crimpers (JST and ferrules)
  • Soldering iron (heat-set inserts, LED wiring)
  • A 3D printer for large parts (tested: Bambu Lab A1, Prusa CORE One, Voron 2.4)
  • A computer to flash the SD card and run the slicer

Skills

  • Basic 3D printing and heat-set inserts
  • Crimping connectors
  • Using a terminal over SSH (the setup commands are all written out)

Materials

  • A Creality Ender 3 (a broken one is fine): extrusion, motors, belts, pulleys, hardware
  • PETG for structural parts and motor mounts, PLA for the rest
  • M3/M4/M5 T-nuts and screws, heat-set inserts
  • Electronics, cameras, servos and pneumatics: see the BOM (Ongoing for V3)

Where the files are

Everything is open source: start from oshe.io or go straight to the repository.

What Repository folder
CAD (STEP, STL, 3MF) CAD/V3-Active/ (Framing, X-Axis, Staging, Feeder, Electrical)
Bill of materials BOMs/
Klipper configuration Software/Klipper/
Machine software Software/pnpvision/
Slicer Software/Slicer/
Photos Media/