Skip to content

1. Daily Startup

  1. Check the work area: nothing on the plate except the board mounts, datum and reject bin; reject bin emptied; tape loaded in F1 (Loading Tape).
  2. Power on the 24 V supply and the servo 5 V supply. The Pi boots in about a minute; the touchscreen shows KlipperScreen.
  3. Compressor on. Let it reach pressure (it cycles by itself). For a long session, put on hearing protection (why).
  4. Touchscreen -> Pick & Place -> Vision home. The machine homes Z, Y and X, then the down camera centres on datum dot 0. Wait for its result message (about 20 s).
  5. Lights: the down light is on from boot. Turn the up light on (Pick & Place -> Lights) if it isn't.

What happens at power-up

Nothing moves by itself. Klipper starts un-homed, the valve is closed, the servos stay limp until the first feed, and no job resumes. The motors switch off after 10 minutes idle (not during a job); after that, Vision home again.

If anything was bumped or changed since last time, run the Recovery Check before the first job.

Next: Make a job, or go straight to Run a job if the job is already on the machine.