Skip to content

FAQ

Who makes it? Students of the Open Source Hardware Enterprise at Michigan Technological University: oshe.io.

Do I need a laptop to run it? No. Load jobs from an SD card or USB stick and run them from the touchscreen. A laptop (or any browser on the same network) is handy for Mainsail and for calibration over SSH.

Does it use OpenPnP? No. The machine runs its own software (pnpvision) on the Pi, driving Klipper. OpenPnP support is an idea on the Roadmap.

Why a job file and not G-code? Placing needs the cameras, the feeders and retries, which plain G-code can't express. The slicer can also write a dry-run G-code of the placements.

Does the board have to be placed exactly? No. Put it firmly in the mounts in roughly the usual place: the down camera finds its exact position and rotation from the alignment pads before every job.

Which parts can it place? Proven: 0603 and 0805 chip resistors with the N08 tip. The tip table covers 0201 - SOIC-8, but those are untested.

How fast is it? About 511 parts per hour on average (7 s per part) with one feeder.

Why is Z "upside down"? Z homes at the top, so Z = 0 is the top and a larger Z is lower. Everything in the docs uses that convention.

What does it cost? Much less than a commercial machine, especially with a donor Ender 3. The V3 BOM with prices is being written.

Can I change it? Yes, please: see Contributing and License.