Skip to content

6. Feeder Hardware

V3 uses the 0816 tape feeder (original design by mgrl), via a low-profile worm-gear remix from MakerWorld that we modified further to fit standard fasteners. A hobby servo pushes a lever that advances the tape by one pocket (4 mm for 0603/0805 paper tape). Files: CAD/V3-Active/Feeder/Tape Alignment (left end, right end, rib); the modified feeder body (Feeder/0816 Feeder) is Ongoing.

  1. Print one set of feeder parts per feeder.
  2. Assemble the mechanism following the original 0816 feeder documentation.
  3. Fit the servo and connect its signal to the Uno: slot 1 = D5, slot 2 = D6, slot 3 = D3 (counted left to right from the front; slot 1 is the feeder against the datum).
  4. Power all servos from the separate 5 V supply and join its ground to the Uno.
  5. Mount the feeder on the front rail, against the datum side.

Current state

Only slot 1 (F1) is in use. F2 and F3 were abandoned for this release (stripped servo gears; a lever that didn't reliably catch and release the tape). See Known Limitations.

Next: how the software drives the feeders, loading tape and teaching the pick position are in Feeders.